Tuesday, 16 July 2024

Making of an Electric Rickshaw loader - Technical Details - Motor Selection

 

Motor Selection

 




* I opted for a high-quality electric motor that could provide sufficient torque and power for the E-loader's intended purpose.

* Considered factors like voltage, current ratings, efficiency, and durability while choosing the motor.

Please find below the calculation I used to select the motor rating.

1.     Gross weight of the vehicle = 1000kg (Including the payload)

2.     Length x Width = 2795mm x 990mm which gives the Area in square meter = 2.767 sq.m (Size depends on the user and government norms for the type of the vehicle)

3.     Wheel size = 12” dia = 0.3048 m ; Radius = 0.1524m

4.     Efficiency = 85% (Since there is very minimal loss in transmission of power from motor to the wheel)

5.     Maximum speed of the vehicle = 25km/h (Vehicle with Low speed category)

Distance travelled per wheel rotation = 2*pi*r = 2*3.14*0.1524 = 0.957m

Convert 25km/h speed in meters per hour = 25000 m/h

Maximum RPM of the Wheel = 25000/ (0.957 * 60) = 435rpm

Choose the motor based on the transmission gear ratio connected to the wheel.

Assuming the gear ratio as 10:1, the motor rpm will be 4350rpm

Force required for driving the vehicle

F(total) = F(Rolling) + F(Gradient) + F(Aerodynamic drag)

F(Rolling) = Crr * M * g

Crr - Coefficient of rolling resistance

M – Gross weight of the vehicle

g – Acceleration due to gravity (9.8 m/s2)

F(Rolling) = 0.01 * 1000 * 9.8 = 98 Newton

To calculate the Power required to overcome the rolling resistance of 98 Newton,

P(Rolling) = F(Rolling) * Speed = 98*6.94 = 680.12W

F(Gradient) = Mass * Acceleration due to gravity * SinØ

Assume to move in flat F(Gradient) is 0. So P(Gradient) = 0W

P(Aerodynamic drag) = Air density * coefficient of drag * Area * velocity3

P(Aerodynamic drag) = 0.6465 * 0.88 * 2.767 * 334.25 = 526.2W

Total Power = P(Rolling) + P(Gradient) + P(Aerodynamic drag)

Total Power = 680.12+0+526.2 = 1206.32W

So the motor power required to move the 1000kg vehicle on flat surface is 1200W

You can choose the voltage rating available in the market for 1200W motor.

I choose 48V BLDC motor. Higher the voltage, higher the speed.

Chosen motor spec is,

48V, 1200W BLDC motor with 3000rpm

Next we move on to the battery selection

No comments:

Post a Comment

Making of an Electric Rickshaw loader - Technical Details - Controller Setup & Charger

  Controller is one of the important component to drive the BLDC motor. We cannot run the motor directly by giving the voltage supply. This ...